Week 14: Materials + Design/Drawing/Safety + Standards

Dec 21 – Dec 27  ·  Phase 2 · Paper-1 GS push

Daily: ~2 hrs weekday (75% technical + 25% Paper-1) · 5–6 hrs weekend. Every subject ends with PYQs solved + mistakes logged. Prelims target ≈ 300/500.

Mon, Dec 21

Material science (types, properties)

Paper-1 GS (main focus today)

EE upkeep (don't go cold)

Note: Phase 2: GS is the priority now (your weak zone), but keep EE warm daily so Phase-1 gains don't fade.

Tue, Dec 22

Design & drawing general principles

Paper-1 GS (main focus today)

EE upkeep (don't go cold)

Note: Phase 2: GS is the priority now (your weak zone), but keep EE warm daily so Phase-1 gains don't fade.

Wed, Dec 23

Importance of safety

Paper-1 GS (main focus today)

EE upkeep (don't go cold)

Note: Phase 2: GS is the priority now (your weak zone), but keep EE warm daily so Phase-1 gains don't fade.

Thu, Dec 24

Standards & quality practices

Paper-1 GS (main focus today)

EE upkeep (don't go cold)

Note: Phase 2: GS is the priority now (your weak zone), but keep EE warm daily so Phase-1 gains don't fade.

Fri, Dec 25

Sectional test on above

Paper-1 GS (main focus today)

EE upkeep (don't go cold)

Note: Phase 2: GS is the priority now (your weak zone), but keep EE warm daily so Phase-1 gains don't fade.

Sat, Dec 26

EE weak-area + GS PYQ

EE (weekend)

Paper-1

Note: Weekend. Use your mistakes notebook to pick which EE subjects to re-test.

Sun, Dec 27

Full mock + deep analysis

Full mock (both papers, timed)

Analysis

Note: Weekend. From Week 16 onward, one full mock every weekend minimum. Analysis matters more than the score.